- Attendees: BruceC, NickB, BlakeS, Vincent
- LG500 "Little Red"
- New PC installed
- clean lens
- cutting 3mm MDF in centre at 25mm/s
- KH7050 "Kellogg/Middle"
- Clean lens
- Adjust Z offset
- Used the z height spacer tool to enforce some offset between lens assembly and gantry. Allows for some room to take up in certain head crash scenarios
- Noted that the threaded locking ring for lens binds in holder. Perhaps the ring is too small diameter. Consider requesting a larger diameter locking ring is manufactured.
- Cutting through around 25mm/s
- LC1290 "Big Red"
- Was in use, didn't work on