Attendees:
Notes:
- Little red
- Cutting fine at around 13mm/s for 3mm MDF, overcurrent at 24mA
- Tube change being pursued
- Require end extension
- Require tube mounts
- Big red
- Was cutting badly ~40mm/s for 3mm MDF
- Inspected lens and found it dirty
- Cleaned lens, mirrors
- Emptied water traps (rear of LC1290 and at main compressor)
- Offset set to 18mm, nozzle to target ~19.5mm
- Cut speeds up to 55mm/s on 3mm MDF
- Hour meter
- The hour meter started from 1.6 hours, at 20171210
- 11.5 hours, at 20171217
- 31.2 hours, at 20171230
- 72.05 hours, at 20180210
- 95.8 hours, 20180305
- 181.65 hours, 20180604
- 234.8 hours, 20180702
- Power up Kellogg the KH7050B
- Kamil has installed a new hall effect (3 wire, purple anodised) Z-probe
- X drive, Y drive, XY datum/reset works
- Z drive jammed? driver stepping requires configuration?