User Tools

Site Tools


tools:swarf-o-mat_usage_instructions

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
tools:swarf-o-mat_usage_instructions [20160111-1105]
jason [Under NO Circumstances Should you use this Machine if you have not been Trained]
tools:swarf-o-mat_usage_instructions [20160111-1106] (current)
jason
Line 70: Line 70:
 **RESPECT THE MACHINE** **RESPECT THE MACHINE**
  
 +
 +=====Instructions for Use=====
   - Place buffer material underneath your job, ensure that the whole area where your job is going to be cut is covered. Its easiest to choose a buffer thats the same size as your raw material.   - Place buffer material underneath your job, ensure that the whole area where your job is going to be cut is covered. Its easiest to choose a buffer thats the same size as your raw material.
   - Clamps are located at the front of the machine. Use at least 4, maybe more depending on the job size. They screw into holes in the bed. Spacers are located in the first drawer - use them to keep the back end of the clamp level.   - Clamps are located at the front of the machine. Use at least 4, maybe more depending on the job size. They screw into holes in the bed. Spacers are located in the first drawer - use them to keep the back end of the clamp level.
/var/www/wiki.artifactory.org.au/htdocs/data/pages/tools/swarf-o-mat_usage_instructions.txt · Last modified: 20160111-1106 by jason