User Tools
tools:lathe
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
tools:lathe [20150517-1707] alex_ynema [Users] |
tools:lathe [20150517-1712] (current) alex_ynema [Instructions for Use] |
||
|---|---|---|---|
| Line 14: | Line 14: | ||
| [[user::alex_ynema]] | [[user::alex_ynema]] | ||
| ===== Instructions for Use ===== | ===== Instructions for Use ===== | ||
| - | FIXME | + | - Place material in chuck |
| + | - Select tooling | ||
| + | - Setup tooling | ||
| + | - Turn lathe on to spin material | ||
| + | - Use tooling to shape material as required | ||
| + | - Turn off Lathe to stop material spinning | ||
| + | - Remove widget created in the lathe | ||
| + | - Return all tooling to appropriate shelving location | ||
| + | - Use dustpan & brush to clean up swarf and place in bin (Swarf can be very sharp and loves bare hands) | ||
| + | - Switch off lathe & lights leaving a clean and tidy workspace for the next user. | ||
| + | |||
| + | **But seriously you need to be trained and know what you are doing to use the lathe is can cause serious injuries.** | ||
| ===== Specifications ===== | ===== Specifications ===== | ||
| ^ Tool Height | 12mm | | ^ Tool Height | 12mm | | ||
/var/www/wiki.artifactory.org.au/htdocs/data/pages/tools/lathe.txt · Last modified: 20150517-1712 by alex_ynema
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 3.0 Unported
