Perth Artifactory

Trace:

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
tools:benchpsu [2010/07/27 15:57]
prd
tools:benchpsu [2020/03/12 12:49] (current)
Line 12: Line 12:
   - With the power supply still turned off, disconnect any loads from its output terminals   - With the power supply still turned off, disconnect any loads from its output terminals
   - Turn the power supply on and turn the voltage control knob until the left LCD displays the desired voltage   - Turn the power supply on and turn the voltage control knob until the left LCD displays the desired voltage
-  - If you do //not// need to set a specific maximum current, set turn the current control knob to 'high'; if you //do//, set the current control knob to just above 'low', short the power supply's output and adjust the current knob until the right LCD displays the desired maximum current, before removing the short+  - If you do //not// need to set a specific maximum current, set turn the current control knob to 'high'; if you //do//, then 
 +    * set the current control knob to just above 'low', 
 +    * short the power supply's output
 +    * adjust the current knob until the right LCD displays the desired maximum current, and 
 +    * remove the short
   - The power supply is now ready to use   - The power supply is now ready to use
  
Line 40: Line 44:
   - With the power supply still turned off, disconnect any loads from its output terminals   - With the power supply still turned off, disconnect any loads from its output terminals
   - Turn the power supply on and turn the voltage control knob until the left meter displays the desired voltage   - Turn the power supply on and turn the voltage control knob until the left meter displays the desired voltage
-  - If you do //not// need to set a specific maximum current, set turn the current control knob to 'high'; if you //do//, set the current control knob to just above 'low', short the power supply's output and adjust the current knob until the right meter displays the desired maximum current, before removing the short+  - If you do //not// need to set a specific maximum current, set turn the current control knob to 'high'; if you //do//, then: 
 +    * set the current control knob to just above 'low', 
 +    * short the power supply's output
 +    * adjust the current knob until the right meter displays the desired maximum current, and 
 +    * remove the short
   - The power supply is now ready to use   - The power supply is now ready to use