User Tools

Site Tools


tools:benchpsu

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
tools:benchpsu [20100727-1557]
prd
tools:benchpsu [20140312-0311] (current)
Line 12: Line 12:
   - With the power supply still turned off, disconnect any loads from its output terminals   - With the power supply still turned off, disconnect any loads from its output terminals
   - Turn the power supply on and turn the voltage control knob until the left LCD displays the desired voltage   - Turn the power supply on and turn the voltage control knob until the left LCD displays the desired voltage
-  - If you do //not// need to set a specific maximum current, set turn the current control knob to '​high';​ if you //do//, set the current control knob to just above '​low',​ short the power supply'​s output ​and adjust the current knob until the right LCD displays the desired maximum current, ​before removing ​the short+  - If you do //not// need to set a specific maximum current, set turn the current control knob to '​high';​ if you //​do//, ​then 
 +    * set the current control knob to just above '​low',​ 
 +    * short the power supply'​s output
 +    * adjust the current knob until the right LCD displays the desired maximum current, ​and 
 +    * remove ​the short
   - The power supply is now ready to use   - The power supply is now ready to use
  
Line 40: Line 44:
   - With the power supply still turned off, disconnect any loads from its output terminals   - With the power supply still turned off, disconnect any loads from its output terminals
   - Turn the power supply on and turn the voltage control knob until the left meter displays the desired voltage   - Turn the power supply on and turn the voltage control knob until the left meter displays the desired voltage
-  - If you do //not// need to set a specific maximum current, set turn the current control knob to '​high';​ if you //do//, set the current control knob to just above '​low',​ short the power supply'​s output ​and adjust the current knob until the right meter displays the desired maximum current, ​before removing ​the short+  - If you do //not// need to set a specific maximum current, set turn the current control knob to '​high';​ if you //​do//, ​then: 
 +    * set the current control knob to just above '​low',​ 
 +    * short the power supply'​s output
 +    * adjust the current knob until the right meter displays the desired maximum current, ​and 
 +    * remove ​the short
   - The power supply is now ready to use   - The power supply is now ready to use
  
/var/www/wiki.artifactory.org.au/htdocs/data/pages/tools/benchpsu.txt · Last modified: 20140312-0311 (external edit)