Perth Artifactory

Subcommittee:laser-minutes-20190610

Laser Subcommittee Meeting 2019-06-10

  • Attendees: BlakeS, Fletcher, NickB, JM, Kym, Justin Richards
  • LC1290 Big Red
    • Speed test cut - cutting fine at 55mm/s on 3mm MDF
    • Tried Fletcher's new focus test piece - cut on swarfomat
  • LG500 Little Red
    • Speed test cut - less than 10mm/s, focus looks out
    • Replace o ring
    • Clean lens
    • Z probe failed
      • Took Kellogg's z probe and installed in little red
      • changed the 5V wire to 24V for the z probe power - no laser pointer possible now
    • Changed offset to 15.5 mm - best of stepped focus piece
  • Kellogg
    • None
  • Lens
    • New lens and o rings arrived. Stored in laser supplies.